DIN Rail Transformer (2nd Generation) for Ring Wired Video Doorbells

Product Information

Connect the previously disconnected 230V high voltage line (brown) and neutral (blue) cables to terminals L & N on the bottom of the transformer.(ensure these are going into the correct input terminals). Remove the wires that run through your doorbell’s solenoid (again, 0 and 3 in this example), and straighten the ends. Then, firmly insert the wires into the Bypass Mode holes on Pro Power Kit. It doesn’t matter which wire goes to each hole. Your transformer is most likely in your fusebox or consumer unit. If not, look in other places where electrical components are installed. It may also be inside your existing doorbell. You can often get a clue to the location of the transformer by looking under the cover of your internal doorbell.

Ring Video Doorbell Pro 2 (DIN Rail Transformer required if your existing doorbell system only works at 8 to 12 VAC) Locate the output cables that are connected to your doorbell. These may be connected to the terminals marked ‘output’, ‘8-12 V AC’ or a similar low voltage. Disconnect these cables and put them to one side.Refer to your local laws and building regulations before performing electrical work. Permits and/or professional installation may be required by law in your area. Your existing chime needs to be bypassed because the DIN Rail Transformer is powerful and runs on DC rather than AC current. Not bypassing will cause damage to your existing chime.

Using the long mounting screws, secure the Corner Mount to the wall through the slots (fig. 3). If you’re re-using existing holes, secure it with the adjacent screw holes (fig. 4).

The real beauty of the DIN rail system is that it was designed (and has continually evolved) to work with to a series of universal standard widths and shapes of mounting hardware. The fact that DIN rail systems are today recognised as a range of fixed and consistent standards means that installers can be guaranteed dimensional uniformity across a whole suite of relevant products, regardless of whichever company is handling manufacture or supply of various individual parts. Mount your Video Doorbell Wired with the two included mounting screws. If you ran the wire through your wall, be sure to feed any excess wiring into the wall first. Ring Video Doorbell Pro (DIN Rail Transformer required if your existing doorbell system only works at 8 to 12 VAC)