Nartel® 10 X 1 AMP SHAVER FUSES BS646 1AMP MINI FUSE 20MM X 5MM

Product Information

So what's the difference, other than the design, between that converter plug and a shaver adaptor (except for the fuse?

Masterplug 3 Pin Fused Shaver Socket Adaptor - White 250V

Both types of shaver socket should be connected through an FCU or Fused Connection Unit, with the lowest fuse rating, normally 3 amp.The transformers in shaver sockets are not to provide low voltages (although, they are of course used to produce 110V). Note: The particular wiring setup in your home may differ from the above, but your electrician will know the best route to take.

Shaver Plug Adaptor, UK 2 Pin to 3 Pin 13A Fuse LENCENT Shaver Plug Adaptor, UK 2 Pin to 3 Pin 13A Fuse

This easy to use design is supplied with 7 jack plug adaptors to suit a variety of socket types and is perfect for travelling abroad. If you are installing in a downstairs bathroom on a wall with a socket or light switch on the opposite side then in most cases it’s possible to take a feed from here and simply pass it through the wall.Once the cable route has been mapped out any chases are cut out and then the correct sized cable is run from the supply location to the shaver socket location via the FCU if required. Once all the wires have been connected, the face plate is then screwed on to the pattress box, fixing it in place. edition on-site guide) all state specific “Zones” in which appliances such as shaver sockets can be installed, see image below. In general, if it fits into a single pattress box it’s an old type (and they do not provide any mains isolation). I'd probablly suggest theese for a visitor from germany but for permanent use having plugs sticking that far out of the wall is just asking for them to get damaged IMO.