About this deal
H265+ uses a different higher level of compression to use less storage but I avoid it as that’s the only benefit. rasite populiariausių Lietuvos parduotuvių - tokių kaip Senukai, Topo centras, Elektromarkt, Avitela, Skytech, Kilobaitas, Fortakas, Technorama, Pigu.
Finally in the cameras webpage menu, you might want to lower the mic volume as it’s a bit loud by default at 80. sensor though I prefer to adjust the exposure up a notch, night time needs additional light if you dont want to use the built in LED lighting, I use a 10w porch light that works to light up my driveway and this works pretty well.If set up that way, it also meant that the white LED illuminator would only work when triggered by an event and so had to be off the rest of the time regardless of how dark it was.
I've hit a dead end with Hikvision support (Hikvision Canada support indicated it's not a North American Camera -> Hikvision International directed me to the vendor -> vendor indicates firmware cannot be rolled back. The DS-2C2347G2-LU now also draws from the same deep learning algorithm that is featured in AcuSense technology. The settings that you'll need to connect directly to the camera for AFTER you've set the rest using the NVR are - disabling the ColorVu LED completely (I think though this may have changed), altering the cameras microphone level and environmental noise filter. This camera utilises deep learning algorithms to reduce false alarms by focusing on human and vehicle targets. Security Password protection, complicated password, HTTPS encryption, IP address filter, Security Audit Log, basic and digest authentication for HTTP/HTTPS, TLS 1.Unless selecting a vari-focal camera (with an adjustable lens) It is important to select the correct camera lens option for where the camera is to be positioned. Settings wise the first recommendation would be to speed up the shutter to 1/100 sec if the nighttime light permits to avoid motion blur on walking targets. See my recent comments on post “choosing cameras for my home”) wait until it’s dark so you can see the effect in real-time of any changes you make.