Everbuild Filler Coat Thick Base Coat, White, 5 Litre

Product Information

It will need to be built up in layers, for the best results. Leaving 6 hours for the filler to dry between each layer. In most cases, you probably won’t need a primer paint for your interior walls. There are some great high-quality paints on the market which render primer paint for interior walls somewhat redundant. Having said this, there are a few cases where you would want to prime your interior walls for a smooth finish.

Affected areas should be treated with Weathershield Multi-Surface Fungicidal Wash. Once rinsed and allowed to dry it can be over coated with your favourite Weathershield Masonry Paint.All you require is a smoothing knife and a tub of filler and you can get to work. I have included our choice of filler below. Allow the surface to dry and then rub down using 'wet and dry' abrasive paper and a solution of warm water and detergent. Once rinsed and dried the area can be repainted. Buying the right primer for your job can be a daunting prospect. You’re in the DIY store and are confronted by endless isles of tins, all looking frustratingly similar. With any painting job, preparing your surface correctly is key to a smooth, professional, and long-lasting finish. Primer paint is a vital step when preparing your surface.

End grain is the result of wood having been cut across the grain and is very absorbent. If you are working with wood with end grain, you’ll need two coats of primer to properly seal the surface and stop your paint and other moisture from being absorbed into the surface. How to Apply Primer Paint If you’re painting a surface that is prone to rusting, zinc phosphate is a rust-inhibitive primer and will stop the metal from rusting. This primer is suitable for all ferrous metal surfaces and can be applied by brush or roller. You will need to clean your brush and equipment with white spirit. It can be tempting to skip the preparation stage when you’re keen to see the finished product and are itching to add that bold colour-pop to your surface.

How The DIY Works Team Tests & Rates Wall Fillers

Using the wrong type of roller can cause foaming of a paint film. Sponge or foam rollers should be avoided with water-based paints. Long pile rollers must be wetted out properly. Foaming happens when air gets into the wet paint film to create air bubbles. When these bubbles burst craters are left on the film surface. Sometimes these craters dry to give an even film. Putting it right

When the surface is thoroughly dry the affected surface will need to be rubbed down using 'wet and dry' abrasive paper. It can then be re-coated. This should only be done once the conditions improve or when the condensation problem is resolved. Newly plastered walls and surfaces are porous, so using a primer before applying subsequent layers of undercoat and paint is key to a great finish.There are 3 main ways you can cover an Artex Ceiling or Wall without the need for plastering. If you have any further suggestions let us know in the comments below. However, using a primer is almost always worth the extra effort. The primer adds a layer between your raw surface and subsequent coats of paint. On porous surfaces, this smooths out the surface, avoiding the need for unnecessary coats of paint later and an uneven final result. Rub down again and add a top coat. Make a judgement call here. If it's not quite smooth enough or you think it needs another top coat, rub down with 220 grit sandpaper, add the final top coat and leave to dry. You should now have lovely smooth, good-looking edges.