16 Amp Double Pole Pull Switch With Neon

Product Information

As stated, in the majority of cases they are used in areas subject to water and moisture as the fact that you have a pull cord to turn the light or appliance on and off you are no where near any electrical internals that could easily have water splashed onto them causing serious electrical injury. Pull the switch free and turn it over to access the wires. Take a picture of the wires (normally just 2), noting exactly which wire is in which terminal. If you want to try and save your broken switch, rather than throw it away and replace it with a new one, work through the steps below for your chosen type of switch. Repairing a 6amp Pull Cord Light Switch In this DIY guide we look at how to install a pull cord switch. Regulations for Installing Pull Cord Switches One thing to note however is that the switches do differ slightly. Whereas the 6 amp switch is single pole, the 45 amp switch will be double pole as it needs to be able to isolate both the live and neutral.

These rules absolutely do apply to DIY activities, so anyone carrying out notifiable work (anything other than the points listed) will have to submit a building notice to the local authority before starting the job and pay a fee to have the work inspected and tested, or simply avoid all the hassle and get a Part P electrician to do it. To save a little time and fatigue, loosen the terminal screws on the new switch also. Step 4 – Connect New Switch

Using a flat blade screwdriver, loosen each terminal for each wire and pull them free, ensuring terminals are loose enough to easily pull them out.

Form a knot and then lower the finial to cover it. Other types of finial are available, such as timber or porcelain/ceramic, from hardware or DIY stores. The neutral wire should also have a brown sheath or brown tape wrapped around it to indicate that it’s the switched live, but this will depend on the wiring setup. As long as you wire it up the same as the old switch, all will be well. Adding additional lighting, light fittings and switches, to an existing circuit – As long as not in a kitchen or bathroom To do this, turn off the MCB of the lighting circuit you’re working on or if a fuse board, pull out the fuse.In most cases, the 45 amp version will have an integrated light and/or on/off indicator that states when the appliance is live and also turned on. Step 1 – Firstly isolate the power to the circuit you are working on in your consumer unit by turning off the MCB for that circuit or if a fuse box, pulling out the fuse. If you are unsure which is which, turn off all the power using the main isolator switch If this is ignored then you may face problems when trying to sell your property as if its had notifiable electrical work carried out, but for which the appropriate certificate from a qualified electrician cannot be produced. Additionally, it will also propably invalidate your home insurance.

For the first part of this guide we will work through replacing a standard 6 amp pull cord light switch. From step 6 we will explain changing a 45 amp isolation switch. Step 1 – Isolate the Switch and Circuit The very first job to do before anything is to ensure the electricity is isolated for the circuit you will be working on. Step 4 – Supporting the switch with one hand, try to operate the pull cord with the other hand to see if the maintenance spray has freed up the spring and therefore the switch should work properly again Step 2 – Undo the two retaining screws holding the switch in place and carefully pull it down a little. There should be sufficient wiring to allow you to do this as with the lighter duty switch aboveAny work other than this must be carried out by a professional electrician with the necessary knowledge to do the work to the regulation standards and also be able fully test it and then issue a minor works certificate once completed. To fit a pull cord switch or indeed just replace the cord, you will need the following tools and products.