SB Skate Ramps | Quarter Pipe | Park Skate | Transition Curve | Self Build | Garden or Driveway Set | Skateboard, BMX & Scooter | Durable Wood Set | Beginner to Advanced

Product Information

A hubba is a concrete or wooden, tall, narrow, and angled ledge that runs down a staircase, bank, or fun box.

Choose a level spot in your yard or driveway to construct the ramp. You will need two 4x4s or two 2x4s for the base of the ramp, and one sheet of plywood for the ramp itself. To the left of the starting point, in the pool area, is a very narrow quarter pipe. Use it to get lots of air Also, you should frame the top with thin, long sets of boards – so that it forms steps. You should start from the bottom edge and end at the top. Attach the Plywood and MasoniteUse the right-hand wing of the plane to ollie over the plane and grind the low barrier in front of it Most of the ramps are built with a quarter circle of constant radius for easy construction, and this method is tried and true. But some of the best ramps are not constant radius but a roughly elliptical with somewhat less final vert (vertical).

Get into the Carlsbad area (via the library roof). Ahead should be a set of steps — ollie down them

Ramp Basics

Cut another piece of plywood into long triangles – depending on the size of your boards. Frame the Bottom and Top

Then, drill three 3/16'' holes - two on either end, about two inches from the edges, and one in the middle.As above, start a manual from the roof, through the glass walkway, and all the way down the corridor to the entrance. You'll want high manual balance stats for this There's a crossbar in the middle of the stage with some bunting on it. Use the quarter pipe to ollie right over it Get to the swing-like arched railings. From there, head into the stone path to their right. Ahead should be a path leading up with a pink rail on the side. You need to air over this path using the banks either side From inside the half pipe, jump and wallride to the quarter pipe next to the large slope and grind it