Globber Ultimum

Product Information

After selecting «Auto» or «On» mode, press the round rubber button to activate your selected mode; press the button again to change the light pattern. Warning! Be careful when you do any installation and transformation work. While turning the T-bar, make sure no other people are in the close vicinity around the scooter since the T-bar turns requires a big turning angle. Keep the kids in a safe distance while installing & transforming the scooter to avoid accidental injuries. ULTIMUM is provided with an adjustable T-bar which can be adapted to the user’s height (6 positions). The spring loaded button shall be in the hole when adjusting the T-bar height.

Standing on the scooter, one hand on each handle, push with one of your feet to move forward. Proceed with caution at the start. A 3.7V lithium rechargeable battery included is not replaceable. - Micro USB cable is included with this product. The easy to use clamp will allow the T-bar to be altered to six different heights, allowing the scooter to grow with the child.Use with caution on a flat, clean, dry surface and, if possible, away from other users, and obey the road safety rules. Do not allow more than one child to ride the scooter at the same time. - Do not use on wet days, or on wet ground.

Battery chargers used with the scooter are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired. Shoes are mandatory and we strongly advise you to wear trousers and long sleeve shirts to avoid injury if you fall. Insert the handle bar (T-bar) tube into the hole at the front of the main board between the two front wheels while paying attention to the direction of insertion. Two high-quality & high-rebound 125mm (43mm wide) front PU casted wheels, and one 90mm (48mm wide) rear PU casted wheel, mounted on ABEC 7 bearings.The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product. Press the button on the bottom of the T-bar and pull it up until it is free to turn. Turn the T-bar and watch the Globber ring around the hole. Align the 2 pins on the T-bar with the slots of the Globber ring, so that it can then be pulled out easily. DO NOT FORGET TO REGULARLY TIGHTEN ALL BOLTS AND SCREWS TO AVOID MISALIGNMENT OR LOSS OF THE SCREW. For your records, save your original sales receipt with this manual and write the product name below.