ELMconfig USB device 500kbit/s ELM327 compatible interface with MS-CAN switch for Forscan FoCCCus OBD2 diagnostics …

Product Information

OK failed at the finalhurdle, after reading firmwear from PCM took 80 minutes then loaded firmware from phf/hex/bin file I will upload a small video in a bit of the center cluster , before i turned off the washer warning :)

C) the tool has been through umpteen revisons and some don't allow you to complete these steps with one version of the tool The type of ELM327 software will all depend on the make and model of your vehicle. The ELM327 microchip is primarily designed to work with modern vehicles that utilize the CAN OBD2 protocol (ISO 15765-4). However, the chip is also compatible with the following OBD2 protocols: Ensure there is NO yellow exlamation marks (that looks like this ) next to devices such as: USB-Serial CH340 | FT232R USB UART Prolific | USB-to-Serial | USB Serial Port | USB2.0-Serial | Silicon Labs CP210x USB to UART BridgeGot the long list above after the car decided to not talk to the PATS module I think and immobilized. Reset fault codes and it seemed happy then Solder pin 14 (which you just de-soldered) to the other middle pin on your switch (middle top in diagram) What i will attempt to do is a guide for the FF2 (russian program) which will allow you to plug in a ELM 327 interface code reader into your focus Mk2 / Mk2.5 and update various parts of your car.

I became particularly fond of the OBD2 system on modern cars. If your vehicle is 1996 or newer, you have an OBD2-compatible car. Without the OBD2 diagnostic system, it will be extremely hard to pinpoint the nuances in your car’s engine. When something goes wrong, it will all turn into a time-consuming guessing game.

ELM327 WiFi Software for iOS Apple Devices

Occasionally you may encounter some errors related to Windows registry. This has nothing to do with software but is about missing files in your computer. Do not change any options with RCM airbag module unless you know what you are doing""¦. Lets not switch any airbags off eh?

ELMConfig can't open a connection to the adapter at all, no matter which mode or laptop I try (Yes, FORScan is closed when I try to use ELMConfig). In all cases, it pops up an error saying "Correct response from adapter timed." Usually, the request and response are both empty, as in this screenshot I took:De-solder pin 14 from the OBD port (Make sure you label this wire if you have not used colour cable)

After the MK3.5 was introduced the FoCCCus software turned out to be not fully functional on the MK3.5. This is because of the different hardware and software version numbers of the MK3.5. At that time the original developer of the program did not plan to modify the program to work with the MK3.5. You cannot read and erase error codes with this software. It does mostly same stuff as ELMconfig but has a different selection of vehicles. Do not use this software if you are not sure what you are doing.

Best ELM327 Software for Windows Smartphones

After you’ve paired the app with your scan tool, you can begin car diagnostics! image courtesy of Chris Running the Car Diagnostics with the ELM327 software FORScan Lite for Android - attention: some functions are missing in FORScan Lite. Please see comparison of applications for me upload / save / write buttons are all named wrongly which is most of the confusion. If it had "Save to PC" and "Write to vehicle" it would make MUCH more sense The GEM Tab or (BCM) , This will not connect , and i'm Guessing that it needs the Wiring MOD before it can connect to the High CAN BUS.