Cisco Catalyst 1000-8P-2G-L Network Switch, 8 Gigabit Ethernet (GbE) PoE+ Ports, 670W PoE Budget, two 1 G SFP/RJ-45 Combo Ports, Fanless Operation, Enhanced Limited (C1000-8P-2G-L)

Product Information

StarTech.com 6 Port Unmanaged Industrial Gigabit Ethernet Switch w/ 4 PoE+ Ports and Voltage Regulation - DIN Rail / Wall-Mounta switch model requires ports 2,4,12 and 20 to be connected with a cross-over cable, and ports 7,14,15 and 23 to be connected Before you install the switch on a wall, or on a table or shelf, power on the switch and verify that it passes POST. Pull down on the DIN rail mount release tabs. As the clips release, lift the bottom of the switch. Figure 12. Switch Removal

Removing and installing an SFP module can shorten its useful life. Do not remove and insert any module more often than is The Cisco Catalyst 1000 Series Fast Ethernet switches are fixed-configuration, Layer 2 and Layer 3 Fast Ethernet access switches After a successful POST, unplug the power cord from the switch and install the switch on a wall, on a table, or on a shelf. Make sure that one member switch has the cryptographic image installed, and that the other member switch has the noncryptographic the default-interface command on the mapped ports. For more information about the command, refer to the Software Configuration Guide.

Deploy secure intelligent switching with Cisco DNA software

The cable guard prevents tampering with the cables after the cables are installed. The cable guard (CMPCT-CBLE-GRD=) is optional. SPAN, with bidirectional data support, to allow the Cisco Intrusion Detection System (IDS) to take action when an intruder is detected. The Cisco Catalyst 1000 Series Switches that support 1-G and 10-G SFP and SFP+ uplink ports can be part of single IP management.

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably Cisco Catalyst 1000 Series Switches include a single fixed power supply. Table 1 shows configuration information. ports do not support autonegotiation, you can manually set the speed and duplex parameters. Connecting devices that do notTo power on the switch, plug one end of the AC power cord into the switch AC power connector, and plug the other end into All the switches are powered through their internal power supplies. The internal power supply is an autoranging unit that supports input voltages between 100 and 240 VAC (max of 90V to 264V). Reliability with a higher Mean Time Between Failures (MTBF) and an Enhanced Limited Lifetime Warranty support (E-LLW).

You can use this application to calculate the power supply requirements for a specific PoE configuration. The results showPer-port broadcast, multicast, and unicast storm control prevents faulty end stations from degrading overall system performance.