Aladdin EasyFit Isolator Valve and Tools Pack - Starter Kit

Product Information

BSP is approximately 14.5mm. If you use the ¼” BSP thread for your radiator, then it will need PTFE tape fitted on the outside of the bush. Fitting Aladdin Autovents to radiators helps increase efficiency by eliminating gas and air from radiators automatically.

Provides an effective and robust product for all plumbers, maintenance engineers, water companies, housing associations and the DIY market.The Micro Barlo fits ‘Roll-Top’ radiators. These have a rolled over steel smooth top to the radiator panel. The left and right edges are welded seams. One model has the bleed pin facing to the wall and on a double panel a second bleed pin also faces outwards. There is also a circular ½” BSP valve (Antrax) which has 3 side ports that allow a U key to be used to rotate the valve and screw in/unscrew from a radiator. Our 1/8” BSP comes with a ¼” chromed adaptor which is 1/8” BSP on the inside and ¼” BSP on the outside.

It may take a few turns to turn the water on. It may also take a few minutes for the water to start running from your taps, as it will need to run through the pipes again. Yes, provided the temperature of the piping allows the valve to operate at 35°C for the Hygroseal™ Autovents. 14) Can the valves work on negative pressure systems? It provides an effective and robust product for all plumbers, maintenance engineers, water companies, housing associations and the DIY market. Aladdin Autovents reduce the volume of air/gas in radiators and helps to maintain their thermal efficiency, thereby reducing the fuel and energy usage.The HV30 model or OEM model (Original Equipment Manufacturer) is a lower cost ½” BSP version with exactly the same mechanism inside, lasting the same amount of time. Yes. Fitting the Autovent should reduce the need for corrosion inhibitors, but we do recommend their use because corrosion leads to further gas collecting in the radiators. 11) Can leak-stop products be used with the Autovent? This is the 1/8” BSP model. We provide a 1/8” Micro model that will fit cast Iron ‘School Type’ radiators (made in cast iron or aluminium section). Yes, the EasyFit Isolator is designed to be fitted to live pipes hot up to 85°C or cold pipes. 2. When the EasyFit Isolator cuts into the pipe what happens to the piece of pipe which is removed?

On a Closed, pressurised system: After the air absorbed in the water has separated, the best early indicator of a leak is a drop in pressure of the system. An Autovent should, if anything, lead to a faster drop in pressure so an even earlier indication of a leak. Your inside stop valve is inside your house and is normally located just after the water pipe enters the house. This is often under the kitchen sink, but can also be: The EasyFit Isolator is a full-flow valve which reduces flow by just 2% (@ 5 bar 30 lit/min) so flow will be 98% of the flowrate prior to fitting the valve. 4. Is the EasyFit Isolator guaranteed?Also can be used when you need to isolate a mains water feed to a multi-occupancy building or to maintain a component in a heating system. Save Time and Inconvenience