Ronseal CRDODO500 500 ml Colron Refined Danish Jac Oil - Dark Oak

Product Information

Danish Oil may be applied to previously oiled surfaces. On previously stained or dyed surfaces it is advisable to test a small area first to make sure that the Danish Oil will produce the desired result.

The key thing to consider here, is how the price of Colron Refined Jacobean dark oak Danish oil 0.5L compares to others but taking into account the quality and features of Colron Refined Jacobean dark oak Danish oil 0.5L over the other options.

Colron Refined Jacobean dark oak Danish oil 0.5L Reviews

Colron Refined Jacobean dark oak Danish oil 0.5L.You can apply this danish oil from the Colron Refined range to using a cloth to colour and provide protection. It takes 6 hours to dry. Our first average we look at for Colron Refined Jacobean dark oak Danish oil 0.5L is to judge it against other products from the same brand, in this case it’s Colron. This tells us that there are a total of 53 Colron products at B & Q. For a smooth, silky finish, lightly sand the danish oil between coats with very fine sandpaper or wire wool The photograph below was taken at a low angle to show the low sheen finish after application and finishing with Danish Oil. Finished This method is suitable when working on large areas, or when there is a limited amount of time available for oiling each day.

Application during the second day was the same as the first. Danish Oil was applied until the wood stopped absorbing. After 20 minutes all excess oil was removed with a clean rag. Day three involved the same process again. By this time the wood was not absorbing much oil, and looked very ‘wet’ after oiling.After 20 minutes the excess oil was removed with a clean rag. Our Danish Oil is based on Tung Oil, and is a penetrating oil which will ‘feed’ and protect wood. Varnished, shellaced, lacquered or heavily stained wood will usually present a surface barrier to absorption of the Danish Oil, and will need to be removed as necessary with a proprietary paint stripper. For a superior smooth danish oil finish, the final coat may be applied using a plastic scouring pad, rubbing in the direction of the grain and wiping away any surplus with a soft, lint-free cloth After another 20 minutes we returned and removed all the remaining Danish Oil from the surface with a clean rag:Apply the Danish Oil liberally with a clean, lint-free cloth or natural bristle brush, and wipe off any surplus oil after a few minutes

Barrettine Danish Oil should be applied at a room temperature of between 15°C - 25°C Do not apply below 5°C. Stir / shake well before use. Always do a small test area to confirm performance and compatibility before starting any project and follow the manufacturer's instructions on the container at all times. To ensure proper drying the temperature should be above 10 Degrees C and Danish Oil should not be applied in damp conditions. Do not apply in direct sunlight. Waxed finishes, and all dirt and grease, should be removed with white spirit on a rag using vigorous agitation.

Colron Refined Jacobean dark oak Danish oil 0.5L reviews

After another hour we wiped the board again, although there were no obvious signs of surface oil at this stage and the board was dry to the touch, with a pleasant low sheen finish. Before and after applying Danish Oil ‘wet on wet’ The performance of Danish Oil will continue to improve naturally for a week or two after application. We recommend that wood should not be subject to heavy use, and any water or other spills should be wiped off immediately during this time. As with any coating, surface preparation is extremely important in getting a satisfactory end result. This method allows Danish Oil to be completely applied during the course of a single day, and the wood to be ready to use after 48 hours. The idea of this method is to keep the wood surface’wet’ with Danish Oil for at least an hour until it has fully absorbed enough oil to provide a natural protective coating from deep within the wood.