Joined in 2023 
82 
63 About this deal
So where to start, I cleaned my entire print head in 99% IPA, then gave the print bed a good sanding to rough the surface up to assist with adhesion of the magnetic plate, after the rough up I cleaned again with IPA. However, if you are not completely satisfied with your purchase for any reason, ELEGOO provides a straightforward warranty that is processed in the most hassle-free way possible. This is a version of my regular Mars 3 build plate holder that uses a magnetic mount instead of the 2020 extrusion mount. REMEBER you MUST relevel the bed following the manufacturers instructions for your individual printer, in some cases you may need to add a spacer for the Z axis sensor, in regards to the Elegoo Mars 2 the sensor is not needed, just make sure you loosen the nuts fully before leveling.
I have a plain ol' Mars (a silver one) on which the platen had been powder-coated and had a typical glaze-like powder-coated semi-gloss finish.
Should any loss be incurred due to the input of an incorrect address or a fraudulent transaction, you will be held responsible as the sole bearer of the pecuniary loss. I have a flex plate for my FDM printer so thought I would get one for my Mars, and came across the Sovol flex plate - I already have the Sovol VATS and going by the quality of them I thought I would give the flex plate a shot. tHE onlt "too much" platen adhesion prolem I have expedrienced was with that damned useless 'water washable' resin.
Beyond the end of those 14 days, refunds for unwanted products are not available, and beyond 30 days, refunds and exchanges for unwanted products are not available. So the next step will be to coat one the sheets in the dark surface finish – probably by cold bluing the steel sheet. That said, I imagine it might work well for printing many smaller minis, but for larger functional parts this wasn't good at all for me. To make it easier to remove the print, flexible surfaces can be used, with which the model can be easily removed by bending it.
This makes it easier to remove prints without possibly causing the build plate to become un-leveled. I printed it on my Ender 3, flipped upside-down with supports and it works fine, although on my original Mars the.
No more spatula scraping and breaking prints from fragile materials (I am looking at you, Elegoo Standard! Our system includes an adhesive-backed magnet base and a flexible build plate made of high-quality spring steel that won't buckle or warp when flexed, but simply snaps back into shape. There is, however, one disadvantage of my current solution – the magnetic stirring bar I use for cleaning the prints sticks to the build plate.I've been using this for over a week now and one thing I am noticing is that the metal sheet warps and lifts from the magnetic sheet.
Great Deal 
New Comment