Everbuild Tecnic Puraflex 40 High Modulus PU Sealant and Adhesive, Black, 300 ml

Product Information

So to summarise, imagine you're an evil man wanting to pull someones' arms off using horses. Tensile strength is the amount of horse's you would need to pull them off which is measured in N/mm2 or MPa. The elongation break is how long the poor persons' arms will stretch before they rip off - ouch! Here is the link to the datasheet for Aquaseal – http://www.everbuild.co.uk/image/data/Tech%20Sealants/mSEAL%20595%20Tech%20Datasheet%20Rev.%202.pdf Specifically designed as an easy flow flooring grade for all concrete saw cuts and floor slab expansion joints where abrasion resistance is required All surfaces must be dry and dust free before using Everbuild Puraflex 40. All flaking or loose surface coatings and any old sealants should be removed before application. In addition to that, when using on glass, metal and aluminium, areas should be cleaned with a proprietary solvent cleaner before application for optimum adhesion. When using Everbuild Puraflex 40 with solvents, always ensure adequate ventilation. Avoid heat, sparks and open flames. Observe and follow all precautions listed on the solvent container label. It is not recommended for application to surfaces that are below 5˚C as it is impossible to guarantee a dry, frost-free surface at these temperatures. Therefore the sealant will most likely fail. It is unlikely that priming will be required; however, concrete must be sealed using a Primer. After that, if you are in doubt, consult Technical Services. PRIMER is all around one part polyurethane adhesive sealant that can be used to bond wood, gel coat and fibreglass. It can also be used above and below the waterline.

Serviceability - how easily will I be able to remove and replace the sealant, how long does it take to set? Elongation Break - Is the % of stretching that the product breaks at. Some sealants have been designed to stretch more than others. A favourite amongst boating enthusiasts CT1 is suitable as a universal adhesive and will work in all applications. CT1 has no shrinkage and can be applied in both damp and wet conditions. It adheres to most metals (including lead) as well as glass, mirrors, wood, polystyrene and GRP.

Stocks we install and supply

We've even created a beautiful acronym for you to remember: 'SFCSS' (pronounced; Suu-Fuu-Cissss). See, if that's not catchy enough for you then I don't know what is! Terms Explained

Remove all of the sealant taking care not to damage the glass or frames, using a sharp knife. Tape the window and frames up using frog tape or blue painters tape then apply the sealant in even smooth beads. Please note the following postcodes are classed as Non-Mainland UK or Remote / Rural delivery: AB, IV, KW, PA, PH, HS, KA, ZE, PO30-PO41, IM, JE, GY, BT, TR21-TR25. Paint types vary so conduct a trial prior to full application. Some paints have low movement and can A non-adhesive sealant will generally rely on the aid of a fitting, screw or bolt to create a waterproof seal. With a normal sealant, you are essentially creating a waterproof gasket. You can't rely on normal sealant to hold anything in place; you are relying on a method of fastening, for example; a screw or bolt. Types Of SealantThis product is recommended for sealing and bonding metal panels and trim. Expansion joint sealing in conrete panels, floor joint, road and bridge construction. Sealing in applications subject to vibration and mechanical abrasion. Marine applications provides resistance to salt water multitude of sealing and bonding applications in the automotive and engineering markets. Bonding in container fabrication.