greenworks 40V Lithium-ion 4Ah Battery - No charger included - 29727

Product Information

One charge cycle describes the timeline between completely charging the battery, utilizing it until it’s fully discharged, and then charging it up once more. If it is exceptionally cold where you usually store/charge your batteries, bring them inside and let them warm up to room temperature and then try charging them again. The speed of a leaf blower is measured in miles per hour (mph). Most leaf blowers offer several speed settings, allowing you to make adjustments based on the type and amount of debris you need to clear. Common speeds for battery-powered leaf blowers range from as low as 60 mph to as high as 150 mph. Air Flow This method means you’ll open the battery to reach the internal reset parts and see the printed circuit board (PCB)

Danger: Lithium batteries can be dangerous when dismantling them. There is a danger of fire or injury – do not attempt this procedure if you are not qualified to do so. If your terminals are corroded: then the corrosion can be removed with a piece of sandpaper or some rubbing alcohol and a Q tip. Frequently Asked Questions About Cordless Leaf Blowers Can my cordless leaf blower also be used to clear snow?No, you should charge the battery after use until it is full, then remove it from the charger and store it in an area that doesn’t get too hot or cold.

Is your Ryobi 40v battery not charging? I have some good news for you; it is possible to fix most Ryobi 40V battery problems yourself. If the second battery charges fine, your charger is fine, and the battery itself is the problem. Try Another Charger When you’re finished using the cordless leaf blower, store it in a safe and secure place, away from the reach of children or pets. Remove the battery if required and store it separately according to the manufacturer’s recommendations. Most Ryobi 40v batteries have a gray button (or buttons) that should be pressed down when inserting the battery into the charger.This may cause you to incorrectly identify the battery charger as being the problem. Power-Cycle Your Charger There will likely be four screws to remove, and some or all of them may be covered by a plastic plug or cover to access them. The powerful G40B2 battery scores additional points with its fast charging. Within less than an hour, it is 100% recharged and ready for use! So that you can get going again in no time. The battery without self-discharge tells you its charge status at a glance with 4 LED lights. So you can see immediately when you can start again. Unfortunately, it could simply be that your Ryobi tool’s 40-volt lithium-ion battery is simply getting old.