UPol DOLPHIN GLAZE PUTTY

Product Information

However, if you’re using it for decent size fills and mixing it with everything, you’ll go through a lot of it. After you’ve sanded the area, U-Pol suggests using a degreaser to clean the panel. I can tell you from experience that using air to blow dust and debris from the panel also works. Application Instead of plastering body filler over minor door dings or a repair that you’ve metal finished, use glaze. If you apply it properly, it’ll have enough build to cover any low spots and will let you finish a repair with 1 skim.

Self-leveling – Depending on how good you are at applying filler, this could be a very helpful feature. As you play around and become more experienced with a product, you’ll know what’s needed for each fill. Mixing glaze with body filler

Gone are the days of localized putty repairs. If you want the best finish, finish your repair with a skim of glaze. At the end of the day it comes down to personal preference and the only way you’re going to know which one works best for you is by trying them out. After application, the glaze should turn to gel within 5-8 minutes and be ready to sand within 15-20. Again, clean the panel after with a degreaser to remove the dust, dirt and debris before filling. The last thing you want is dirt in your filler, this is what leads to defects such as pinholes. Application

Free Delivery is not available for Over-Sized parcels, such as Exhausts, Radiators & Headlamps - For details on these items please see the 'Oversized Items' section below.

One of the major benefits of products such as dolphin glaze is the fact that it can be applied over paint. It’s even recommended by U-Pol themselves! Finally, it’s pretty common for technicians to mix glaze with body filler. Doing this will make a deep-filling Bondo thinner and much easier to apply. Easy To Sand – Dolphin is designed to be rubbed with 120-320 grit sandpaper. So it has to be easy to sand, otherwise, it’d take forever. Using and mixing glaze with plastic fillers and aluminum fillers will make them much easier to apply and rub, you should definitely try it. As long as you work your way through the grits, you’ll have a smooth finish with zero imperfections. Cost

Using a lot of glaze and little to no pressure on the spreader will also allow you to do deeper fills if needed. For the initial rub it’s recommended that you use 180 paper before finishing off with 240. This is more than enough if you’ve done a light skim to fix imperfections. Putting a final “skim coat” on top of your repair will completely change the quality of your repair. I’ve had painters thank me for this in some workplaces. Using the guidelines above, you can expect to rub your filler after 20 minutes. It’s recommended not to use more or less hardener, it speeds up the process but can also result in defects later on. Rubbing Dolphin Glaze is multifunctional and can be applied to bare steel, aluminum, galvanized steel, original paint, Body filler & GRP.Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie. Dolphin Glaze is a premium finishing glaze that’s designed to eliminate pinholes and other surface imperfections prior to painting. I’m most familiar with Dolphin glaze and use it all the time, that’s why I recommend that over any other. U-Pol Dolphin Glaze If you pull the metal out as much as possible, use a body filler, and then glaze it’ll last forever.

METAL GLAZE is a two-part polyester finishing and blending putty. Just like dolphin it can be mixed in with other body fillers to offer flexibility and completely change the products you’re working with.After filling and rubbing body filler, you may have various imperfections left. These can range from pinholes, scratches, and even paint edges.