Joined in 2023 
82 
63 About this deal
Hosing is what supplies the nail gun with the power it needs to run smoothly. The quality and state of the hose will affect the amount of pressure exerted. Pneumatic nail guns have unique maintenance tasks that need to be performed, but there are also some general maintenance tasks that apply to all nail guns – corded, cordless and pneumatic. Screw and Bolt Inspection When it comes to the motor, your attention should be on the impeller blade. Use, brush, aerosol, and a piece of cloth to clean the blade and to wipe out any leaked lubricant. #2. Clean and lubricate the feed system Having a nail gun or nailer is a smart investment, especially if you are into DIY construction or home improvement. For example, a brad nailer or a pin nailer will help you with lightweight projects around your home, whereas a flooring nailer will come in handy when installing a hardwood floor.
Nail Gun Maintenance Tips 101: Cleaning and Lubrication Guide Nail Gun Maintenance Tips 101: Cleaning and Lubrication Guide
The air fitting is a crucial part, and you’ll need to oil it regularly if you are using the nail gun daily. For best results, apply 4 to 5 drops daily. This amount should be enough to get your gun running for long hours. The air fitting has several O-rings inside, and you’ll need to keep them lubricated; you can lubricate them using your fingers. However, always ensure that the power is cut off, and there are no nails in the gun before putting your fingers inside to avoid serious injuries. #5. Use the right nail oil Don’t panic- it’s alcohol based so it will not hurt the O-rings or other seals (you probably know that brake parts feature plenty of rubber) or even electrical parts of the tool. Don’t worry if a small amount of smoke comes out from your nailer – this is normal. Your Paslode Also Needs Regular ServicingIn a nutshell, using it as a Paslode nail gun oil substitute will be calling for trouble and more expenditure down the road unless you can, of course, prevent it from getting on the sensitive parts somehow.
Paslode | Screwfix Paslode | Screwfix
Step 3: inside the motor chamber you’ll find 4 nuts that will need to be removed using the Allen key. A red cable marks the spark charger which will need to be removed and the power supplied needs to be decoupled A pneumatic nail gun’s seals need to be changed from time to time. A bad seal can cause the tool to lose power and may damage the nail gun if left in disrepair. Because pneumatic nail guns are powered by an air compressor, they require a little more maintenance than their battery- and electric-powered counterparts.While holding the air hose connector in an upright position, add few drops of the recommended oil through the air inlet port and re-connect your machine to the air hose. Pull the trigger several times to help spread the oil throughout the machine. Loading...