Razer Panthera Evo: Fully Mod-Capable - Sanwa Joystick and Buttons - Internal Storage Compartment - Tournament Arcade Stick for PS4 and PS%

Product Information

Unless properly calibrated to your printer and viewing environment, your monitor does not accurately represent the brightness of paper. Artwork submissions may need adjustment to ensure prints are not too dark. Please read this helpful support article for more information Search through the rubber bands and try to find 8 of the smallest bands you can find. Now, place an LED on one of your buttons as best you can. If you do not intend to replace the pushbuttons, the process to replace artwork is complete. You can now reverse the steps to reattach the tinted acrylic cover. You're basically done! To make your life a billion times easier, use two of the screws you set aside from the beginning and screw down the razer pcb with them. Use the remaining two screws to secure the Breakout to the other holes in the case. Just make sure not to screw down the breakout too much, as there's no protective casing at the bottom, and you don't want to accidentally damage it. Zip-tie or shove the wires in whatever way you please, and you're good to go! If you're confused on which way to plug in the harness into the Mini, just plug it in so that the empty pins are on the left side of the Mini, like This.

Razer Panthera Evo arcade fightstick review | PC Gamer

NOTE: YOU DO NOT NEED TO USE ALL 8 GROUND PINS ON THE RAZER PCB!!! The Razer 16-pin harness had 8 individual wires that each connected ground to a different button. However, your new 20-pin harness that connects to the Kaimana Mini uses 1 ground wire that daisy-chains to every button. This means you only need one ground wire for all of the buttons. I corroborated this with a certified electrician, so no need to somehow condense 8 ground wires into 1 wire for no reason whatsoever!The artwork, a large blue Razer logo, is essentially the same as the original. The big plus, this time around, is that the artwork can now be changed easily. Then, daisy-chain your LED's and connect them to your Mini. Here is a great tutorial on how to do this: https://www.youtube.com/watch?v=mKty1h_pj54 In some instances, a button brand or model does not have a 24mm equivalent with art cap. In this case, we will cut to the default size of Sanwa 24mm insert.

set up the Razer Panthera How to set up the Razer Panthera

Removing the original Razer pushbuttons requires disconnecting the wires that are attached to the .110" terminals on each button. It is recommended that you do not attempt to pull with a wrench or your finger; the design of the button microswitch can easily bend and distort from the force, possibly damaging the button terminals. Instead, use needle-nose pliers to grasp the disconnects by their tabs (circled in green), then squeeze in and upward. If the tabs are pressed in correctly, the disconnect should lift with just a bit of effort. If you find much resistance, retry pinching the pliers around the tabs and squeeze again.You now need to separate 11 of the Jumper Wires from each other, so you have 11 individual wires. You need to remove the Plastic Casing from the male ends of each wire. Now, you can choose the button insert cut to match the pushbutton you intend to use. This allows the insert to fit snugly within the cap. Brands and Model with Artwork Caps