About this deal
Siblings to the Crosscut Station are the Kreg Rip-Cut which attaches to a circular saw to make straight, accurate rip cuts. Will usually dispatch within same working day if paid before 13:30 GMT (excludes weekends and holidays). I personally think this new tool is going to change the way people work on a job site, much like how the pocket hole jig changes how people approach woodworking.
Because you’re putting screws into MDF and plastic, an impact on full torque will strip everything out. The Crosscut Station is a great option for DIYers who have a miter saw, but their miter saw is mounted to a workbench. Could use some improvements such as saw guides made out of heavier material they do move slightly with the weight of saw. Make a variety of angle and miter cuts from 0° to 45° with the adjustable fence and molded-in angle alignments. The Kreg Crosscut Station KMA4100-INT is the perfect solution for precise and efficient crosscutting and ripping.Make a variety of angle and mitre cuts from 0° to 45° with the adjustable fence and moulded-in angle alignments. The Crosscut Station gives you the capabilities of a mitre saw with just a circular saw and Kreg guided cutting, allowing you to crosscut boards wider than most compound mitre saws can handle (up to 12" at 90°). Please do not hesitate to contact our in-house Sales Team via live webchat for Free of Charge technical advice. When the fence is set for 45 degrees, the maximum width of the board that can be cut is a 1×4 or 3-½”. So it’s a great option if you already have a compound miter saw but it’s not in your budget to upgrade to a sliding miter saw.
Easy and precise cross-cutting with full control up to 305 mm workpiece width (at 90° to the workpiece). Circular saws are versatile, but they don’t usually cut straight without a little help from a fence or a guide. Kreg offers you a whole system of drilling templates for pocket hole joinery, our "Pocket-Hole Jigs".Just know that if you’re using an impact driver like I did, but light on the trigger or turn it down to the lowest torque level.