Owatrol 1 Litre Net-Trol Wood Cleaner by OWatrol

Product Information

New wood surfaces have a hard shiny surface called mill glaze that prevents maximum penetration and bonding of any finish; sanding or treating the wood with Aquanett removes this, ensuring maximum performance of the finish. Weathered wood surfaces (untreated) Easy to apply, Dilunett dissolves paint in even the smallest of recesses and the finest of details, softening all the layers for a simple and clean removal. After stripping and cleaning, allow the wood to dry for 2-3 good drying days before applying Deks Olje D1. D1 may only be applied to bare wood surfaces or a weathered wood surface that was previously finished with Deks Olje D1. All other finishes must be completely and thoroughly removed first. If necessary sand the surface after cleaning and/or stripping (100 grit paper). New wood Deks Olje D1 must be kept ‘active’, this is done by the ‘wet on wet’ applications and the continual brushing over of the area, which assists and helps achieve maximum penetration. D1 has high penetration; its place is in the wood and not as a surface coating. Allow 3 days for D1 to set-up and dry, before use or in marine uses before putting the boat in service or continuing with Deks Olje D2. Temperature is of very little importance when applying D1. Clean Up Unlike two-part cleaners, it is mild to use, harmless to plants and shrubs whether used full strength or diluted.

Net-Trol is biodegradable and so it is not harmful to plants or animals. This means you don’t need to worry too much about covering surrounding areas – unless you don’t want them to get wet of course! We would however, recommend thoroughly wetting surrounding plants once you finish. Preventing rust marks caused by garden furniture Dilunett is a solvent and paraffin free paint stripper that will remove any oil and alkyd based paint, varnish or woodstain. Dilunett’s powerful formula strips up to 8 coats of finish in just one application. Suitable for almost any surface such as wood, metal and plastic, Dilunett’s gel consistency means it will not run, making it ideal for us on vertical surfaces, elaborate plaster or wood designs that are in need of being stripped. Leave the Net-Trol to stand for approximately 15 – 20 minutes. If the surface starts to dry, you must moisten it again by using a spray of mist application of water.Regular washing with Net-Trol will help to maintain the appearance of Deks Olje D1. It will gradually lighten over time due to exposure to the sun and UV rays. When the wood has lightened to a light grey colour, it is time for a maintenance application. Clean the surface with Net-Trol and then apply Deks Olje D1 until the wood is saturated and the finish restored, usually 1 or 2 applications will be sufficient. Restrictions

Can be used on most surfaces; on wood (some woods such as Oak and Chestnut require more attention before using Dilunett), metal (except Aluminum), plastic, stone, cement etc Leave to stand for around 10-20 minutes. If the surface starts to dry, dampen with a mist application of water. As garden furniture and equipment is often metal it can rust when exposed to the delightful British weather leaving unsightly marks on your patio. These stains can be particularly stubborn and generally cannot be removed using water alone – even if using a pressure washer. Always read the Dilunett Gel Product Information before using and follow the instructions carefully. Superficies horizontales o verticales: terrazas, revestimientos, vallas, cubiertas de barcos, muebles de jardín, …To help to prevent rust marks from re-appearing we would recommend coating your garden furniture with Owatrol Oil– it will prevent damage caused by moisture and should help to prevent unsightly rust marks too. Owatrol Oil is a colourless and odourless rust inhibitor and provides enhanced corrosion protection.

Remove any loose and flaking finish. Brush off any physical surface contamination e.g. moss, general dirt etc. Shake or stir product well before and during use including diluted solutions. After rinsing ALWAYS neutralise surface with Net-trol except where Tropitech is the chosen finish (see “After stripping/cleaning”). Do not use a wire brush to scrub the surface.Owatrol Net-trol Wood Cleaner and Brightener is a powerful solution which restores weathered, greying unfinished exterior wood to its natural colour. Owatrol Net-trol is mild to use, and unlike chlorine or bleach-based cleaners will not damage the wood fibres. While restoring the wood's natural vibrancy, Owatrol Net-trol also removes any ground-in or surface dirt, resulting in a beautiful, clean-looking exterior wood surface. Wet surface with fresh, clean water. Apply Owatrol Net-Trol. Scrub surface to agitate the Owatrol Net-Trol. Leave to stand for approx. 10-20 minutes. If surface starts to dry, dampen with a mist application of water. Scrub surface while flushing with water or use a pressure washer (max. 60 bar/870 psi). Rinse thoroughly with fresh clean water. If required repeat procedure.

After an appropriate time, test a small area with nylon scrubbing brush to see if finish or dirt is lifting. Sometimes knowing which Owatrol product(s) you need for your wooden restoration project can seem a little bit daunting. Cover and protect everything you do not wish to strip, including plants and shrubs and any aluminium surfaces. Net-Trol can be used neat or diluted up to a maximum of 1:4 with clean water depending on surface condition. Next, scrub the surface with a stiff nylon scrubbing brush again and rinse with large amounts of fresh clean water (you could use a pressure washer here to make your job easier if you have one). For particularly stubborn rust stains you may need to repeat this process again.Ideal for surfaces difficult to strip due to size or intricate design and horizontal and vertical surfaces.