RJ45 to RJ11 Converter Adapter Connector M/F Cable,Uvital Telephone RJ11 6P4C Female to Ethernet RJ45 8P8C Male Converter Cord(2 Pack)

Product Information

To achieve a delay free use of your PS4, you will need a proper ethernet network cable installation(CAT5e, CAT6 or CAT6a). However, trying to convert an RJ-11 to an RJ-45 adapter is ill-advised, since there aren't enough wires and telephone wire isn't designed to accommodate the digital signals used in network cables. This is important since the unterminated wires must remain twisted, which helps to minimize signal interference. Overall bandwidth is, of course, contingent upon what other components of the network such as cabling or routers can support.

The biggest differences between these cables and telephone cables is the quantity of copper in the cable (the more the better) and the twists between the individual wires. Slide all the wires as far as possible into the connector so the insulation is flush with the rear of the connector. Making a cable for your DSL modem using both RJ-45 and RJ-11 connections allows you to save money and use as little or as much CAT5 cable as you need for your project.

In fact, the RJ45(S) jack — as defined in the standardized spec — is rarely used, but the RJ45 commonly refers to any 8P8C modular connector used in computer networking (Ethernet). RJ45 connectors can support 10Gbps over Ethernet, provided the other equipment like network cables also support that speed.

If you need to use a length of cable with RJ-45 connectors in an RJ-11 application, you can purchase an adapter. As shown in the schematic above, RJ45 uses an 8P8C configuration, which means 8 Positions and 8 Contacts (or connectors, or conductors). Using 8 contacts allows for greater bandwidth so RJ45 is used for data-intensive applications like Ethernet and can support bandwidth up to 10Gbps. I am assuming you use it for gaming and video streaming and you would like to enjoy a delay free experience. RJ-45 connectors are usually attached to a CAT-5 or Cate-5e cable with eight wires, commonly used in computer networking.

A registered jack (RJ) is a standardized network interface for connecting voice and data telecommunications equipment. Standard registered jacks, known as RJ-type jacks, are found in nearly every communication and data system. If you can find a telephony cable that is not cut and is a "home run" between the two points you need to connect, and it contains at least 4 conductors, it may be possible. All three jack types are used to connect phones—for one-, two-, and three-line service respectively. Connect both ends of the cable the same to an RJ45 JACK (do not crimp ends on the cable), essentially we are going to substitute color pairs of the existing cable for "standard" color codes in EIA/TIA 568B color code.