Gyproc Plasterboard Patches various sizes 12 Pack (2 x 50mm, 5 x 100mm & 5 x 150mm))

Product Information

Gyproc EasiFill 20 has a working time of 20 minutes and the second coat can be applied after 40 minutes. Gyproc EasiFill 45 has a working time of 45 minutes and the second coat can be applied after 80 minutes. The two main repair methods can be found below: Repairing a Plasterboard Hole Using a Piece of Plasterboard or Timber

Once the adhesive has dried enough to support the patch you can now push the screw out into the wall void. Leave for a further 24 hours for the adhesive to completely harden off and then you can start filling. For larger holes locate the joists either side of the hole in the ceiling and mark the middle with a straight pencil line and create a rectangle around the hole. Cut out and add two noggins to bridge the gap between the joists. The first thing to do is to cut out a rectangle around the hole using a steel rule and a Stanley knife. Alternatively, mark out with a pencil and ruler and cut out with a jab saw. Find Gyproc EasiPatch Plasterboard Patches at your local decorator centres and builders’ merchants. Find the details here . As you will need to do a bit of cutting, before you start this, firstly run over the area around the hole with a wire detector to make sure there aren’t any wires, pipes or other items that you may accidentally cut through.Remove any loose bits from the edge of the hole or damaged area, and sand this down. Remember to always wear eye protection when sanding. Another way to fill a hole in plasterboard is to enlarge the hole first to make a square of a suitable size. Then cut two battens (19 x 38mm timber will suffice) and make sure they are 100mm longer than the size of the square you have cut. Once the first coat has set if you find any ridges, lumps, bumps or trowel marks, gently scrape these away using the edge of your filling knife, or leave to fully dry before sanding. Gyproc EasiFill 45 is also available in handy 1kg sachets in our Gyproc EasiFill 5×1 boxes, perfect for smaller jobs like application of plasterboard patches.

Measure and cut a new piece of plasterboard to fill the hole. Fix in place with plasterboard screws or nails. Mix up plaster, apply and leave to dry. Once the patch is dry and firmly in position, gently remove the screw. Use patching plaster, all purpose filler or multi-finish plaster — mix up enough to cover the patch and gently press into the hole and spread with a putty knife that is larger than the hole to help get a smooth finish.Use a digital stud detector to locate studs, noggins and joists in walls and ceiling (Image credit: Getty Images) Can I Use Caulk To Fill Holes? Feed a batten into the hole and twist it so it is either upright or horizontal and one third of the distance either up or down or across the hole. Make sure you have a 50mm overhang either side of the hole.