Alien Abduction Lamp The Original UFO Flying Saucer LED Night Light

Product Information

To attach it, I de-soldered the black battery lead from the PCB and soldered the battery holder black lead in it's place, then desoldered the end of the red lead from the resistor, and resoldered the resistor lead to the red lead from the battery holder. With the three mounting holes drilled around the rim of the bowl, you can place the bowl on top of the plate, and either mark and drill the holes in the plate, or tape the bowl securely to the plate (LOTS of tape! During the construction process I managed to destroy both of the acrylic glasses AND the bowl, so I had to go back and get another set of glasses, and at the same time, discovered that Safeway had holiday bowls of almost the exact shape I was looking for on a close-out sale, so I got one of those to replace the one I had broken.

The alien abduction desk lamp is is turned on and off using a toggle switch located on the power cord. I think it’s awesome but I would have bought a solar led light (like those cheap ones for the garden) and put the solar panel on top drilled more holes so the light shines out the sides and put little pieces of clear colored plastic glued over the side holes then used a square scrap piece of wood, glued indoor out door fake grass and some mini trees around and used that as a base.An energy efficient touch control colour changing LED lighting, giving a polaris effect similar to your planet's Northern Lights; or stealth mode if you need to avoid detection. This required cutting a hole in the bottom of the glass big enough for the LEDs to shine through, but not too big to prevent mounting holes from being drilled around the edges. The three small holes were carefully drilled in the glass to match the holes in the reflector, and three more holes for mounting the plate to the glass, and then I tried to get fancy.

I marked the center of the bowl, measured the diameter of the switch barrel, and drilled a hole that size. Put the acrylic glass upside down on the table, put the large bowl right side up on top of the glass to test for fit. Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item.I countersunk each hole so that the mounting screws would be flush with the surface and less visible. Sightings of UFOs aka flying saucers are a wild fantasy dream or intriguing depending on which side you’re on.

The ray is enhanced by pigment added to the glass, allowing for the use of a low wattage bulb to achieve the same effect of a much more powerful spot lamp. In addition to the beaming-up Bessie, the table lamp's flying saucer also sports glow-in-the-dark little green men heads with bulbous eyes peeking out of each of its windows. This amount includes seller specified domestic postage charges as well as applicable international postage, dispatch, and other fees.With all three screws in place, thread a nut over each screw where it protrudes from the bottom of the plate, tighten them down, and except for some finishing details, your Alien Abduction Lamp is now complete. ALIENS - The Alien Abduction Lamp comes with three glow-in-the-dark alien pilots that peer out from the spaceship’s porthole windows, scanning the surrounding area for potential abductees. The light lights up the cow, and shines down inside the glass, making the glass look just like a transporter beam. I’m a big sci fi fan especially of the aliens and i have ton of those little quarter machine aliens that I’ve collected and this will be a cool way to put them to use.