LICHIFIT Gearshift Mount Shifter Support LHD TH8A Bracket for Playseat Challenge Chair for Logitech G25 G27 G29 G920

Product Information

For the upgrade I was contemplating a RAM mount solution, but that would have made it a lot more expensive then my current solution. The surface is not wide enough to use the rear clamps effectively, but you will want to use the front screw clamp. With all of your feedback, listening to your issues in mounting many products and certain products design flaws. Their maybe, in some cases, cosmetic additions included that further enhances the Lowdown Shifter product experience. Extends back towards the seated position to reduce the reach required to the shifter and buttons, and to make it feel more natural.

LICHIFIT Gearshift Mount Shifter Support LHD TH8A Bracket for

I've never claimed to be the sharpest tool in the shed, but I don't see how that attaches to the challenge chair. When looking from the outside bracket in, I used the top 2 on the far right, the bottom right, and top left. If using the bottom left, you'll need to use an M4 screw, or a wood screw of the correct size, no more than 30mm.

Heavy duty, mechanical secure replacement clip for the attachment of the velcro strap to the tubular construction of the Playseat Challenge.

DIY Playseat Challenge Logitech Shifter mount : r/simracing DIY Playseat Challenge Logitech Shifter mount : r/simracing

For some reason, every time I make a change to this design, I need to execute the Combine-Cut functions again for the part<>Screw_Hole_Tools before exporting to STL. By accepting all cookies, you agree to our use of cookies to deliver and maintain our services and site, improve the quality of Reddit, personalize Reddit content and advertising, and measure the effectiveness of advertising. I couldn't find a Logitech shifter mount on Thingiverse that satisfied me, so I made my own in Fusion 360. I just get them started by pressing them into their holes slightly, then use the screws to pull them into place. So the product had to deliver the same experience to which side of the road/highway you would really drive.

I printed this with red MatterHackers PLA Pro, with print settings as described in the 'Print Settings' section. This will ensure changes propagate to the 'Left' versions, as well as the 'Print_Bodies' component, of which you use to export the bodies for proper orientation on your print bed. Any longer and the screws will extend beyond the inside bracket, which is fine, but causes an exposed sharp surface. If printing in ABS, you may want to increase the size very slightly to ensure you can get the nuts into their recesses and so the brackets fit around the tubing.

Playseat Challenge Shifter Mount - How to mount a Shifter

Compatibility - Interface Plates fits on The Ultimate Mod Mount System+ Centre Control Stick System + Trophy Mod Mount System. Low down Shifter Phase 2 Mod Interface products are constructed from ahard impact composite material. By rejecting non-essential cookies, Reddit may still use certain cookies to ensure the proper functionality of our platform. I suggest printing this as it imports into your slicer with the base on the print bed to ensure strength where the bracket attaches to the surface. I'm not sure how well this part would hold up with M4 screws attaching the surface to the bracket, but I expect it would be fine.I can't remember the exact one I got but it might have been the reinforced angle bracket 80x50x70 code 152816.